Craftmade Triumph Manual Del Usuario página 7

1
Step 1 - Flushmount Option
Prior to securing Mounting Bracket/Plate, screw "J" Hook (S8) into
Ceiling Outlet Box as a secondary support means. Secure mounting Plate
(1A) to the outlet box (A) by tightening Bracket Screws & Washers (S3)
as shown. If not mounting to an outlet box, use wood screws (S1) and
washers (S1) and mount securely to ceiling beam. Be sure at this point to
insert Canopy Screws (S2) in bracket.
NOTE: Do not mount directly to sheet rock or ceiling tile.
NOTE: J Hook installation is a Canadian requirement only.
"J" Hook (S8)
OUTLET BOX
Ceiling
Ground Wire
Bracket Screws
& Washers (S3)
Helpul Hint
Remove fan motor (#4) from inside the box, turn the top foam insert
upside down, then lay the fan motor face down into the foam. This
will hold the motor housing steady during assembly.
All manuals and user guides at all-guides.com
Support Beam
Outlet Box (A)
Mounting Plate (1A)
Wood Screws (S1)
2
Step 2 - Blade Assembly
Take out the four screws in the Top Motor Housing (#4). Save the
screws. Raise the Top Motor Housing (#4) off the base (see figure 1).
Slide blade (#5) through slot on side of fan. Attach with Blade Screws
(S4) as shown in figure 2. Repeat this procedure until all five blades are
secured. Tighten firmly. Top Motor Housing will be reattached in
following step.
Figure 1
Figure 2
Top Motor Housing (#4)
Motor Housing (#4)
Blade Screws (S4)
Top View
CAUTION: Never hold or lift fan by blades