Safety Instruction - NEC MultiSync 80 Manual Del Usuario

MultiSync sound bar 80 Quick Start
To connect the MultiSync sound bar 80 to the monitor:
1. Turn off the power switch of your monitor.
2. Place the MultiSync sound bar 80 under the monitor. Slide the attachment tabs (Figure 3) to
allow attachment to the the monitor. Slide the attachment tabs as far as possible.
3. Connect the audio cable to the jack on the back of the MultiSync sound bar 80 (Figure 2) and
the other end to the "Audio out" terminal of the computer.
NOTE: Headphones may be connected to the "Headphones" output on the front of the
MultiSync sound bar 80. Headphones can be purchased from your local electronics store.
4. Connect the power cable (L-Angle connector) to the power connector of the MultiSync sound
bar 80 and the other end (Straight Angle connector) to the DC-OUT connector on the back of
the monitor (Figure 4-Figure 5).
5. Turn on the monitor and the MultiSync sound bar 80.
Troubleshooting
LED on "MultiSync sound bar 80" is not lit
• Power switch with volume control should be in the ON position.
• DC power cable should be connected.
• The monitor maybe be turn into "Power Saving Mode" or "OFF".
LED on "MultiSync sound bar 80" is lit by amber
• Audio cable should be connected.
No sound
• Check to see if audio cable is properly connected.
• Check volume setting.
• (No sound on speaker): Check to see if headphone is not connected.
• (No sound on headphone): Check to see if headphone is properly connected.

Safety Instruction

Do not open this unit. There are no user serviceable parts inside and opening or removing covers
may expose you to electric shock hazards or other risks. Refer all servicing to qualified service
personnel.
Check the stability of the LCD monitor after installing the MultiSync sound bar 80. The LCD
monitor, with the MultiSync sound bar 80 installed, should not overbalance when tilted in any
direction to an angle of 10 degrees from its normal upright position.
Follow the other safety instruction and the other notice that the user's manual of the LCD monitor
instructs.
Please do not move only with a MultiSync sound bar 80.
MultiSync sound bar 80 Specifications
Power
Input Impedance
Input Sensitivity
Frequency response
Power Requirements
Current Rating
Headphone/Audio Input Jack Type
Dimensions (without projections)
Weight
Note: Technical specifications are subject to change without notice.
All manuals and user guides at all-guides.com
1 + 1 Watts @ 8 Ohms with 10% THD
> 40k Ohms
500mV input for full output
300Hz - 10kHz
DC 12V
0.5A (at the typical output)
3.5mm Stereo
12.4 in (W) x 2.2 in (H) x 2.3 in (D)
315.2mm (W) x 55mm (H) x 59.5mm (D)
0.9 lbs / 0.4kg