H-8539
BENCHTOP ROTABIN
7/16" Wrench
Flathead
Screwdriver
Stem x 1
1.
Slide the top of stem through the bottom of base
plate. Push base plate down until it is flush with stem
plate. Align holes in base plate with holes in stem
plate and secure base plate to stem plate with three
bolts and three keps nuts. (See Figure 1)
Figure 1
2. Set unit upright and insert pin through bottom hole in
stem closest to base plate. Position pin so that equal
distance of pin is on both sides of stem. (See Figure 2)
Figure 2
PAGE 1 OF 3
1-800-295-5510
uline.com
®
PARTS
Base Plate x 1
Bearing x 4
Washer x 4
ASSEMBLY
Stem Plate
Shelf x 4
Bolt x 3
3. Slide washer down stem until it is resting on pin. Slide
bearing down stem until it is resting on washer. Slide
shelf down stem until it is resting on bearing, washer
and pin. (See Figure 3)
Figure 3
NOTE: Bearing, washer and pin should sit in
recessed circle of underside of shelf.
4. Repeat steps 2 and 3 for remaining shelves.
Para Español, vea página 2.
Pour le français, consulter la page 3.
Pin x 4
Keps Nut x 3
Shelf
Bearing
Washer
Pin
0421 IH-8539