Operational Function; To Answer A Call; Making A Call (Manual Selection); Speakerphone - Linkcom Link 680 DECT Manual De Instrucciones

All manuals and user guides at all-guides.com
Introduction
When your cordless is in standby mode, i.e. no calls or operations are being made, the heading "
on the display (the number identifying the cordless).
• When you receive a call, both handset and base start ringing, the
the red led on the handset locator button and the big white led on the phone base start flashing. If your
cordless is directly connected to the telephone line (not via PABX) and the Caller Details Service has been
activated by your server, the caller's telephone number (if available) appears on the display.
• Press the button to answer the call, the symbol
led will flash.
• To end a call, press again the
symbol and the base red led disappear.
• Press button.
• The symbol appears steadily on the display and the base red led starts flashing.
• Check that the dial tone is present then key in the number.
• The dialled number appears on the display.
• To end the call, press again the
To activate the speakerphone, press the
button.
The speakerphone is active if you can hear the caller voice coming from the speaker and can see the
symbols on the display
back to standard from a spekerphone call, just press briefly the button.
• When handset is idle key in up to 25 digits.
• You can check the digit on the display before starting your call.
• If you make a mistake, press shortly the
digits, press and hold the
• When number is checked, press the
• At this point digits are selected and dialled.
• To end the call, press the
Note: If you have a PABX connection you need to pause for a few seconds between dialing the system code
and the actual phone number.
To pause, press the
DECT GAP Link 680

6. OPERATIONAL FUNCTION

6.1 TO ANSWER A CALL

will come up steadily on the display and the base red
button, or alternatively replace the handset back in the base. The display
6.2 MAKING CALLS (MANUAL SELECTION)
button or alternatively replace the handset back in the base.

6.3 SPEAKERPHONE

button when the handset is idle or after having pressed the
(hold repeatedely the Volume button to adjust the speaker volume). To switch

6.4 PRE-SELECTION

DEL
button to clear digits one by one from the display; to clear all
DEL
button.
button to start the call.
button again, or replace the handset back in the base.
button and a dash "-" will appear on the display.
HS-1
symbol appears on the display, and both
11
" appears
and