Desoutter E-LIT BOX Manual De Usuario página 3

English
Original instructions.
© COPYRIGHT 2014, DESOUTTER HP2
7SJ UK
All rights reserved. Any unauthorized use
or copying of the contents or part thereof
is prohibited. This applies in particular to
trademarks, model denominations, part numbers
and drawings. Use only authorized parts. Any
damage or malfunction caused by the use of
unauthorised parts is not covered by Warranty or
Product Liability.
STATEMENT OF USE
This product is intended to be used to drive,
monitor and control the E-LIT range of tools.
No other use permitted.
For professional use only.
OVERVIEW
Main features
The E-LIT BOX module is able to communicate
with a wireless screwdriver from the Desoutter
E-LIT range.
For example:
- send specific orders to a screwdriver to drive a
batch of tightening cycles
- drive digital outputs according to cycle results
sent by a screwdriver.
If other commands are required to
monitor the screwdriver, contact your
Desoutter representative for support.
Technical data
Input voltage
filtered and regulated,
SELV (safety extra low
voltage), circuit with a non
dangerous energy level
Input current
Weight 550 g
Protection level IP54 (1)
Using
0-45°C
Temperature
IP address 192.168.5.214
Wireless protocol 802.15.4 standard
Default serial communication:
Baud rate 19,200 Baud
01/2014
9-30 V
0.25 A - 0.3 A
Parity
Data length
Stop bit
(1) all connectors and cap properly connected.
Front panel
LED name
POWER
OK
NOK
REHIT
REVERSE
BATCH_COMPLETE
MAINTENANCE_ALARM
TOOL LOCKED
TOOL READY
Bottom panel
1 2
POWER
INPUT
1 J1 M12 male connector
Power supply and digital inputs
3 / 36
6159931280_05
none
8
1
Color
green
green
red
yellow
yellow
blue
yellow
yellow
green
OUTPUT ETH
Series: -
3