Prilux BURA ÉLITE Serie Instrucciones De Montaje página 5

BURA ÉLITE
Ø360
BURA 50W 90º
IK08
IP65
NOTE
BEFORE INSTALLING THIS PRODUCT, PLEASE READ THE
INSTRUCTIONS CAREFULLY AND STORE THEM IN A
SAFE PLACE.
THE INSTALLATION SHOULD BE CARRIED OUT BY
TRAINED STAFF.
INCORRECT HANDLING OF THE PARTS OR THE
LIGHT FIXTURE ITSELF MAY IMPAIR THE PROPER
PERFORMANCE OF THIS PRODUCT. IN THIS CASE,
THE MANUFACTURER GUARANTEE SHALL BE DEEMED
VOID.
THE MANUFACTURER GUARANTEE SHALL BE DEEMED
VOID: IF THE INSTALLATION IS NOT PERFORMED IN
ACCORDANCE WITH THE SPANISH LOW VOLTAGE
ELECTROTECHNICAL REGULATION 2002 (REBT 2002).
THE APPLICATION OF IBC BT09-4 OF REBT (INSTALLATION
OF LINE AND LIGHT FIXTURE SURGE PROTECTORS) IS
ESSENTIAL FOR INDUSTRIAL AND PUBLIC LIGHTING
INSTALLATIONS. THE GUARANTEE DOES NOT COVER
AGAINST DAMAGES CAUSED BY SURGES IN LIGHT
FIXTURES WITHOUT SURGE PROTECTORS INSTALLED.
ATTENTION!!!
OBSERVE
PRECAUTIONS
HANDLING
SENSITIVE DEVICES.
Ø460
BURA 100 90º
FOR
ELECTROSTATIC
[GRÁFICOS: Unidades en mm/ GRAPHICS: Units in mm/GRAPHIQUES: Unités en mm/GRÁFICOS: Unidades em mm]
Ø561
BURA 140W/165W 100º
PRECAUTIONS:
• Keep out of reach of children.
• Do not immerse this product in water or handle it with wet hands.
• Do not hit the product.
• Do not install the product where there are heat sources or moisture
concentrations.
• Do not handle the product while it is in operation and let it cool before
touching it with your hands.
• Keep a minimum distance of 1m with the surface or object to be illuminated.
• The product must not be covered by thermal insulation material in any
case.
• If the product is damaged, replace it immediately with a new one.
• Disconnect the power before installing the product.
• This product contains components sensitive to static electricity and a
discharge on it could destroy or damage its components.
• Before proceeding with any handling or maintenance, make sure that the
appliance is completely disconnected from the power supply.
• The replacement or maintenance of any component must be done with
the same elements recommended and supplied by the manufacturer. If
this is not the case, any incident in an installation that has not been carried
out in accordance with this instruction sheet will be the responsibility of
the installer.
• The light source of this luminaire must be replaced only by the manufacturer,
its technical service or equivalent qualified person.
abril 2019
Ø561
BURA 140W/165W 60º
loading