Utilitech Pro WL160206 Manual Del Usuario página 6

OPERATING INSTRUCTIONS
Recharging the light
The batteries in the light have been shipped in a low
charge condition to prevent possible problems.
Therefore, you should charge it prior to use.
The charge time is 3 to 4 hours when the light is
powered off.
1. Turn the light off.
2. Insert the output & USB plugs of the included cable
into the socket (I) and adapter (H) separately.
3. Insert the power plug of the adapter (H) into the
power supply.
4. When the charge indicator (F) comes on, it will be
red to indicate it is charging.
5. After 3 to 4 hours, the charge indicator (F) turns
green, indicating charging is finished.
NOTE: The adapter should be stored inside the storage
case (G) at the back of the light when it is not used.
ON/OFF switch button
The On/Off switch button (E) is at the back of the light.
Push the switch button (E) to cycle high mode (1500 lm),
power off, low mode (750 lm), power off.
NOTE: If the switch is powered off for more than 10
seconds, the light always starts in high mode when it is
turned on again.
For full charge, the work light will use up to 2 hours at high
mode or 5 hours at low mode.
Adjusting the light direction
The lamp head (C) can be adjusted freely to the desired
angle.
With one hand securely holding the folding stand (D), use
the other hand to adjust the lamp head (C).
2
3
E
4
C
D
6
H
F
I
G
A