Operation
Before using the Remote Controller, be sure that
the shower door is closed to avoid water spillage.
Use of Main Controller, see fold-out page I
Start / Stop Button
Starts and stops the shower at a pre-set temperature
(default 38 °C) and mid-flow rate.
Pause Button
Pauses the shower. Shower restarts at previous
settings when pressed again.
If left in pause mode, the shower will switch itself off
after a preset time (default 5 minutes).
Memory 1, 2 and 3 Buttons
Start the shower at the saved water temperature
(default is 38 °C) and flow rate settings.
To save a new memory setting, hold down the button
for 5 seconds. A tone will sound to confirm a setting
has been saved.
Temperature Knob
Increases (clockwise) or decreases (anti-clockwise)
the water temperature.
The display flashes until the set temperature is reached.
Flow Knob
Increases (clockwise) or decreases (anti-clockwise)
the water flow rate.
The volume display indicates the flow rate in 12 steps.
Temperature Override Button
Allows a temperature higher than a pre-determined
safe limit (default 38 °C) to be selected. If the red
light illuminates, it must be pressed before setting
a higher temperature.
After touching any button or knob on the Main Controller,
a backlight is illuminated (default 10 seconds).
The shower will switch off automatically if the Main Controller
is not actuated for a pre-set time (default 30 minutes).
Battery indicator (Main Controller):
Full battery display
Half battery display
Outline battery display
Outline battery flashing
and BATTERY displayed
(accompanied by an audible tone every 30 seconds when
shower is active)
= Battery full
= Battery half full
= Battery low
= Battery very low
Messages:
If SERVICE 13 is displayed and the shower stops, this means
that the system has protected the user against a water
temperature exceeding the pre-set safe limits (see MAXTEMP
in section Settings). Reasons can typically be strong
fluctuations in the water supply pressure or a large difference
in the system inlet pressures.
Use of Remote Controller, see fold-out page I
Start / Stop Button
Starts and stops the shower at a predetermined
temperature (default 38 °C) and medium flow rate
settings.
Memory 1, 2 and 3 Buttons
Starts the shower at the saved water temperature
(default is 38 °C) and flow rate.
Memory buttons can only be programmed with the
Main Controller and are then automatically updated
on the Remote Controller.
When starting the shower using the Remote Controller, a high
flow rate is initially achieved which then falls back to conserve
water once the desired temperature is reached. The desired
flow setting is rachieved again by pressing the relevant
flashing button on the Main Controller.
The shower will switch off automatically following a pre-set
time after the Remote Controller has been used to start it
(default 5 minutes). Using the Main Controller deactivates the
Remote switch off timer.
Once the Remote Controller is used to start the shower, it can
only be used to stop it. This avoids external tampering of the
shower settings once in use. The Main Controller always has
full control.
All default settings mentioned above can be changed by
entering the Main Controller SETUP menu. Changing these
settings can have an affect on battery life.
Battery indicator (Remote Controller):
ON/ OFF button flashes every 30 seconds when batteries
need changing.
6