Hiyasu ASE 7TB Manual De Funcionamiento página 54

06Manual 3Hiyasu Eng 7/4/06
COOL, HEAT and DRY operation
Recommendations:
(1) Unit start
Press ON/OFF button, unit starts.
Previous operation status appears on display. (Not Timer setting)
Power indicator on indoor unit lights up.
(2) Select operation mode
Press MODE button. For each press, operation mode changes as follows:
Unit will run in operation mode displayed on LCD.
Stop display at your desired mode.
(3) Select temp. setting
Press TEMR button.
Every time the button is pressed, temp. setting increases 1ºC.
Every time the button is pressed, temp. setting decreases 1ºC.
Unit will start running to reach the temp. setting on LCD.
(4) Fan speed selection
Press FAN button. For each press, fan speed changes as follows:
Unit runs at the speed displayed on LCD.
In DRY mode, when room temp. becomes 2
temp. setting, unit will run intermittently at LO speed
regardless of FAN setting.
COOL operation starts when room
temp. is higher than temp. setting.
Temp. setting + 2ºC
Temp. setting
Hints
On cooling only unit, heating mode is not available.
Remote controller can memorize each operation status. When starting it next
time, just press ON/OFF button and unit will run in previous status.
52
09:28 Página 52
OPERATION
• Use COOL in summer.
• Use DRY in spring, autumn and in damp climate.
o C lower than
Ultra-low air flow
On reaching temp. setting, unit
will run in mild DRY mode.
• Use HEAT in winter