brennenstuhl Jet Light 38 W IP 54 Manual De Instrucciones página 18

Instructions manual
5.1.5 To re-assemble the worklamp, place the cover in its original position and put the
rubber protection over the cover. Then screw the cover back on with the 4 screws.
(Fig. 17).
PCE
1050
IP54
5.2 Changing the starter
5.2.1 Follow the instructions in 5.1.1 and 5.1.2 to open the cover then make sure you use a
starter with a capacity between 5W and 65W.
5.2.2 Remove the used starter: Turn the starter in a clockwise direction and pull it out of
its holder. (Fig. 18).
PCE
1050
IP54
5.2.3 Insert the new starter: Press the starter in the starter holder and turn it in a
clockwise direction. (Fig. 19 and 20).
PCE
1050
IP54
5.2.4 Assembling the worklamp according to 5.1.2 .
Attention!
After assembling the worklamp, make sure the cover is stable and is completely enclosed
by the rubber protection so that water cannot penetrate and damage the lamp.
18
Fig. 18
IP54
Starter
Fig. 19
Jet Light 38 W/55 W IP 54
Fig. 17
PCE
1050
Fig. 20