Uline H-6601 Instrucciones De Montaje página 2

1. Flip storage tray on its side.
2. Using 25 mm bolts, attach casters to storage tray.
Make sure wheel plates are in correct direction.
(See Figure 1)
NOTE: Locking wheels should not be diagonal
from one another. For each caster, be sure to
insert each of the four bolts into position before
tightening.
Figure 1
Locking Casters
3. Set storage tray on its wheels.
4. Using 15 mm bolts, attach each upright support
beam onto outside of storage tray. (See Figure 2)
NOTE: Bottom end of upright support beams
have first two holes measuring 4" apart. This
end should be attached to outside of storage
tray. Make sure bolts are tight.
Figure 2
PAGE 2 OF 9
ASSEMBLY
5. The base of the storage tray has three walls. The side
that does not have a wall on the storage tray should
be faced forward. Using 15 mm bolts, attach three
crossbars with screw holes (facing up) to upright
support beams on both left and right side of storage
tray. Do not fully tighten bolts. (See Figure 3)
Figure 3
Crossbar with
Screw Holes
6. Using 15 mm bolts, attach three crossbars without
center screw holes to upright support beams on
the front and back side of storage tray. Do not fully
tighten bolts. (See Figure 4)
Figure 4
Crossbar
without
Center
Screw
Holes
4"
Crossbar
without
Center
Screw
Holes
0521 IH-6601