PALSON Diabolo Modo De Empleo página 7

GB
c) Clean the dirt from the filter (5).
d) Replace the filter (5) into the tank (10).
e) Press down the tab lightly and reinsert the tank (10) into the robotic vacuum.
Cleaning the main brushes (12) on the robotic vacuum.
1. Turn off the robotic vacuum and place it upside down on a flat surface.
2. Use a star-head screwdriver to remove the right attachment screw, then remove the main brush
(12), rubber brush and brush connector, as shown in the following diagrams:
3. Clean the brush chamber and remove any detritus from the brush and rubber brush.
4. Clean off any dirt found on the shaft, the metal connecting bracket and on the brushes (this may
not be necessary after every use) as shown in the following diagrams. Apply lubricant if necessary.
12
All manuals and user guides at all-guides.com
Brush connector
5. Reinstall the brush connector and brushes and tighten the screw.
Cleaning the robotic vacuum inlet cover (13)
1) Turn off the device. Place the robotic vacuum upside down on a flat surface.
2) Place the robotic vacuum inlet cover (13) as shown in the following diagram.
3) Clean the robotic vacuum inlet cover (13) and the fan-shaped mechanism to ensure correct
ventilation.
4) Carefully seat the connecting tabs on the robotic vacuum inlet cover in their corresponding
holes.
Recharging
The robotic vacuum must be recharged after each use. The light, robust charger is designed for 230V
outlets (voltages differ from country to country) with a frequency of 50/60 Hz. It is especially designed
for our robotic vacuum; please do not charge the device with any other charger.
How to recharge
1. Turn off the device. Put it in a safe place.
2. On the right hand side of the device there is a socket and a recharging light. Total recharging time
is around 4-5 hours.
3. When recharging, the robotic vacuum indicator light will turn on, indicating that the device is
charging correctly. After 4-5 hours, the battery will be fully charged and the charger should be
unplugged.
Once fully charged, unplug the charger to avoid overloading the battery which may affect its
working life.
CAUTION
1. The charger (2) supplied with this unit is designed with a particular voltage, stability and reliability
and is to be used exclusively with the rechargeable battery provided. Do not use the rechargeable
battery (15) or charger with other products.
2. To prolong the working life of the battery, charge it for 8-9 hours after its first use or when reusing
it after a long period of inactivity.
3. The battery will reach its optimum performance level after 2-3 full drainage and recharging cycles.
13