N-Gear Drum Block 420 Manual De Usario página 4

Using a Microphone (Included)
STEP 1: Insert a microphone connector into the mic. input port.
STEP 2: Adjust the volume of the microphone using the mic. volume control dial. Rotate it in a
clockwise direc on to increase the volume; decrease the volume by rota ng it in an an clockwise
direc on.
Warning: When using the microphone, give the speaker a 1 meter exclusion radius; being too close
may cause loud feedback and could damage the speaker.
Using the Drums Pads
The speaker must be turned on before using the drum pads. To turn the drum pads on, slide 'ON/OFF
DRUMS' to the 'On' posi on. To turn the drum pads off, slide 'ON/OFF DRUMS' to the 'Of posi on.
Modes
The speaker must be turned on before using any of the following modes.
Bluetooth Mode
STEP 1: Once the speaker has been turned on, the LED indicator light will flash blue and a tone will
sound to signal that the speaker is ready to be paired.
STEP 2: Search for the speaker using a Bluetooth compa ble device. Select 'FE3967' to connect and
pair. Once a connec on has been made, the LED indicator light will remain blue to signal that the
device is paired with a Bluetooth compa ble device.
STEP 3: To unpair or remove a Bluetooth compa ble device from the speaker, turn off the Bluetooth
func on on the compa ble device. The speaker can now be paired with a new compa ble device.
Note: Once connected, sound can be controlled using the master volume control dial or the relevant
controlson the Bluetooth compa ble device.
Aux. Mode
Connect one end of the line-in Aux. cable to the Aux. input port on the speaker and the other end to
an MP3 player or other compa ble audio source.
The speaker will automa cally switch to Aux. mode once the line-in Aux. cable has been inserted.
Note: Once connected, sound can be controlled using the master volume control dial or the relevant
controls on the compa ble audio device. The speaker cannot be used to skip tracks during Aux. mode.
Troubleshoo ng
The speaker has no power.
The speaker has run out of charge. Charge the speaker following the instruc ons in the sec on