Care And Maintenance - NORPOLE NPPAC8KW Manual Del Propietário

All manuals and user guides at all-guides.com

CARE AND MAINTENANCE

IMPORTANT
1) Be sure to unplug the unit before cleaning or servicing.
2) Do not use gasoline, thinner or other chemicals to clean the unit.
3) Do not wash the unit directly under tap water or a running hose.
It may cause electrical danger.
4) If the power cord is damaged, it should only be repaired by the
manufacturer or a qualified service technician.
1. Air filter
-
Clean the air filter at least once every two weeks to prevent
inferior fan operation because of dust.
-
Removal
This unit has two filters. Grasp the upper filter tab (Fig.25), pull
the filter out then up. Remove the lower filter by loosening the
screw, taking down the air inlet grill, then removing the air filter
as shown in Fig.26 & 27.
-
Cleaning
Wash the air filter by immersing it gently in a solution of warm
water (about 104°F /40°C) and neutral detergent. Rinse the filter
and allow it to dry in a shady place.
-
Mounting
Insert the upper air filter after it has been cleaned, attach the
lower air filter onto the air inlet grill, then install the grill by using
the screw.
2. Unit enclosure
- Use a lint-free cloth soaked with neutral detergent to clean the
unit enclosure. Finish by drying with a clean cloth.
3. Unit idle for an extended time
-
Remove the rubber plug on the back of the unit and attach a
hose to the drain outlet (See Fig.22 & 23).
-
Remove the plug from the bottom drain outlet allowing any water
in the bottom tray to drain out (See Fig.24).
-
Keep the unit running on FAN mode for half a day in a warm
room to thoroughly dry the interior and prevent mold from
forming.
-
Once dry, stop the air conditioner, unplug, wrap the power cord
and bundle it with tape (See Fig.28). Remove the batteries from
the remote control.
-
Clean the air filter and reinstall it.
-
Unscrew the exhaust hose by turning to the right or left and pull
out for un-installation (See Fig.30). Keep in a safe location.
Cover the window (wall) hole with the adaptor cap.
-
Place the open end of the drain hose directly over the drain area
in your basement floor
15