WOOD'S MDK11 Manual De Instrucciones página 11

TANK FULL
DEFROST
OPERATION
1. Plug into power socket and then press
the "ON/OFF" button to turn on the
unit. The machine start up automatically
and the unit is in the status of constant
dehumidifying.
2. Press the "HUMIDITY" to set desired
humidity 40%»60%»80%»CO .
CO is indicated a continuous
dehumidification, dehumidification
equipment without humidity setting , no
humidity control
If the humid reduce to the setting
humidity ,the machine will stop
automatically.
Example: in the dehumidification
operation: Set the 50%--- expectations
of environmental humidity value is 50%,
when the appliance detects that the
current environment humidity is higher
than or equal to 55%RH, the appliance
start; when the appliance detects that
the current environment humidity is less
than or equal to 49%RH,machine stop
dehumidification, dehumidification (if the
machine start, stop flashing)
3. Press "TIMER" to set the working hour of
units 2h»4h»8h»No timer.
4. Press the ""ON/OFF" button to turn on
the unit."
WATER FULL
When the water container is full, an alarm
signal will be produced.- the compressor
will stop automatically, this will also stop
the dehumidification process.
07
HUMIDITY
HUMIDITY
Empty the water container and replace it
in the correct position, the dehumidifier
will continue dehumidifying when the
compressor, automatically, starts after
three minutes.
WATER DRAINAGE
If desired, it possible to connect the
drainage tube (Optional) to the device
for permanent water drainage. Simply
connect the included drainage hose to
the drain spout and ensure that the end of
the hose is lower than the drain opening,
otherwise the water will not drain and
flooding may occur.
DEFROSTING
When the machine is in the environment
of low temperature during operation, the
surface of the evaporator may frost, in
order to ensure the normal operation of
the machine, machine is provided with an
automatic defrosting function.
MAINTENCANCE AND CLEANING
For its casing is made of plastic, do not
place it in direct sunlight.
Remove the water tank with care.
If not using the unit for a long time. Please
Switch off and unplug the unit, empty
the water reservoir,, keep it in dry and
ventilated place.Only use a soft clean
cloth for all cleaning purpose. Do not use
gasoline, paint thinner or other chemicals
Operating Instructions
TIMER MODE
TIMER BUTTON ON/OFF
to clean the unit.
Cleaning mesh filter: Remove the filter
usse a vacuum cleaner or water to clean,
then put it in ventilated place until it's dry.
GB
11