Chapter 4 Troubleshooting - Acard AEC-6293M Guia De Inicio Rapido

Chapter 4 Troubleshooting

After installed AEC-6293M, if it cannot work normally, please refer the checklist below to solve the
problem.
A. Mac cannot boot up after install AEC-6293M HBA.
It could be:
1. AEC-6293M touch area with PCI slot are not clean, please use rubber to clean touch area.
2. Install the AEC-6293M not properly, please re-install it again.
3. PCI card conflict with AEC-6293M, please remove other card and install AEC-6293M first.
B. Mac cannot defect the HDD/ ODD device after device is connected.
You may:
1. Inspect if the power cord's connector of SATA/ IDE HDD/ DVD device connected well, or if
the power supply watt is not sufficient.
2. Inspect if the jumper setting on the hard drive is Master or Slave in IDE port.
3. Inspect if the connector of SATA cable loose or damaged.
C. Can not load driver or update BIOS to AEC-6293M
It could be:
1. Download wrong driver or BIOS.
All manuals and user guides at all-guides.com
9
AEC-6293M Manual