Control And Functions; Turning On The Amplifier - Ground Zero TITANIUM Serie Manual Del Usuario

Controls and functions – GZTA 1.1200DX
5
All manuals and user guides at all-guides.com
Интернет-магазин автозвука и автотоваров Винавто

Control and functions

1 Speaker terminals For connection of the subwoofer
GND -> Ground connection
Power terminals
2 REM -> Remote antenna terminal
BATT -> +12 Volt
GREEN – OK
3 Satus indication
RED – Error
Terminal for connection of the RCA wires.
4 Cinch inputs
To avoid failure, please use high quality RCA wires.
5 Input level controller With this controller you can adjust the input sensitivity.
6 Bass boost controller For adjusting of the bass boost level in the range from 0 to +12 dB.
Adjust the variable lowpass frequency to the desired frequency
7 Low pass controller
between 30 and 250 Hz using the controller.
8 Master / Slave Switch For choosing the operation mode of each amplifier in link mode.
9 Cinch Outputs For connection of additional amplifiers in fullrange operation.
10 Remote control input For connection of the bass remote control.
This controller allows you to fit the subwoofer channel in-phase to the
11 Phase shift controller
front system.
This controller allows you to filter low frequencies in a range between
12 Subsonic controller 10 and 50 Hz. This function reduces the mechanical Xmax and raises
the capacity of the connected subwoofer.
Master/Slave Cinch In- / Output for operation of two same amplifiers (2x GZTA
13
Cinch-In-/Output 1.800DX or 2x GZTA 1.1200DX) in linkmode.

Turning on the amplifier

The amplifier automatically turns on a few seconds after you turn on your radio.
Note: Your amplifier temporarily shuts down if it gets too hot, then restarts automatically once it cools
(At about 80° / 176° F).
Adjusting the audio level
1. LEVEL (Min/Max): Turn fully counter- clockwise to MIN position
2. Turn the auto sound system's volume control to about two-third of its full range.
3. Adjust LEVEL to a comfortable listening level.
6