Before Initial Use; Assembly And Settings Of The Device - Hoberg GT100 Traducción Del Manual De Instrucciones Original

EN

Before Initial Use

• Assemble the device (see the "Mounting and Settings of the Device" chapter – "As-
sembly").
• Attach the cutting elements you want (see the "Assembly and Settings of the Device"
chapter – "Attaching / Detaching Cutting Elements").
• Charge up the battery (see the "Charging Up the Battery" chapter).

Assembly and Settings of the Device

Assembly
1. Place the edge guide (8) with the inwardly curved side at the bottom on the trimmer
unit (11) and press it on. When you do this, make sure that the castor of the edge
guide is pointing to the front left.
2. Place the protective cover (9) with the outwardly curved side at the bottom on the
edge guide and press it on. When you do this, make sure that the protective cover
is oriented backwards.
3. Use the two screws and the tool which is supplied to screw the protective cover and
the edge guide securely on the trimmer unit from below.
4. Insert the telescopic rod (5) into the corresponding mount on the trimmer unit.
You must hear and feel it engage.
5. Undo the two screws on the extra grip (3) so that it is split into two parts.
6. Now place the extra grip above the fi xing (4) on the telescopic rod and hold the
counterpiece at the same height on the telescopic rod from below. Make sure that
the textured side of the grip is pointing towards the trimmer unit.
7. Use the two screws to screw together the two parts of the extra grip and fi x it on the
telescopic rod at the same time. When you do this, make sure that the screws are
screwed tight enough so that the extra grip cannot slip.
Proceed in the reverse order to take it apart. Please Note: To detach the telescopic
rod, press the release button (6) and pull the telescopic rod out of the trimmer unit at
the same time.
Attaching / Detaching Cutting Elements
The device can be used both with cable ties and with a trimmer thread as the cutting
element. These are attached as follows:
1. Lay down the trimmer unit (11) so that the bottom is facing upwards.
2. Hold the rotatable end piece of the trimmer unit securely with one hand, at the same
time undo the locking screw anticlockwise and remove it.
3a. Introduce two cable ties into the recess of the thread (A) and fi x them with the
locking screw (B) (Picture B1 + B2) OR
3b. Introduce one trimmer thread into the recess of the thread (A) and fi x it with the
locking screw (B) (Picture C1 + C2). When you do this, make sure that the marking
on the trimmer thread is positioned in the thread.
Proceed in the reverse order to take it off.
20