Mounting The Camera - Hawke 46100 Manual Del Usuario

The SD card must be clean (no images from other sources). If you are using the SD card from
another camera, please make sure to format the SD card prior to using in the camera. SD card
capacity is shown in the lower right of the display screen.
PIR SENSITIVITY (MOTION DETECTION)
The camera has three PIR sensitivity settings: "H" (high), "M" (medium) and "L" (low). The PIR
switch is located under the display screen. If you want the camera to detect long distance targets
or small animals, use the "H" (high) sensitivity setting.

MOUNTING THE CAMERA

The camera should be mounted approximately 1.2 to 1.5 meters off the ground with the camera
pointed at a slight downward angle. Avoid mounting the camera facing east or west as the rising
and setting sun can produce overexposed images. Ensure the camera lens and PIR sensor (motion
detector) are not blocked by any branches or debris.
Insert the strap through the slots on the rear of the camera. Wrap the strap around the mounting
surface. Secure the strap and tighten the buckle. Ensure the camera clasp is closed to obtain proper
weather resistance.
CAMERA COVERAGE
Mount the camera in the location it will be used. Open the camera and press the "Setup" button.
Close the camera. After 30 seconds a red light on the front of the camera will blink when you enter
6