Idiomas disponibles
Idiomas disponibles
Installation Manual
INSTALLATION
The heater has to be fixed to the wall. Use the 4 screws to fasten the metal plate as
shown on the diagram below.
460 mm
The heater can be connected directly the pool pipeline with 50 mm or 63 mm
diameter.
To use the heater in the best conditions, it is advisable to observe the following
parameters in the case of a water treatment with chlorine :
pH between 6.9 and 7.5
Free chlorine between 0.4 and 1.4 mg / L
In the case of different water treatment, the installer will ensure compatibility with the
equipment.
Note : 1 mg/L = 1 ppm
Hydraulic connection
The heater must be installed before any water treatment device. It is strongly
recommended to keep the pipelines of the heater filled with water. After
stopping the pump, the heater must not be emptied by gravity.
The heater can be inserted into a pipe of diameter 63 mm or 50 mm. In 50mm case,
the two adaptor provided must be affixed to both ends of the heater. No additional
piece of PVC is required.
The heater is equipped with a flow switch. From factory, the heater is configured to
operate with water moving from left to right. (See diagram below).
FILTER
CCEI
All manuals and user guides at all-guides.com
v1.0
EN
420 mm
BLEU TITANE RTi-U
To the pool
To any water
treatment device
p 4
Capítulos
