Instructions Of Use; Maintenance And Cleaning; Environment Protection - Jata BT575 Instrucciones De Uso

• Make sure neither the appliance nor the cable are in direct
contact with hot surfaces or objects.
• Always disconnect it from the mains when you do not use it
and before assembling / disassembling or when cleaning.
• Do not leave the blender plugged in if it is not going to be used.
• Take all necessary precautions while handling the blade, as it is
very sharp. The wrong using of the appliance can cause injury.
• If the cable were to deteriorate it must be changed by an
Authorised Service Centre.

INSTRUCTIONS OF USE

• Before you plug the blender in, assemble the accessory you are going to use.
• VERY IMPORTANT: The rods with the slots in the edge must be placed in the toothed hole of the blender.
- MIXING RODS (8): For liquid mixes, creams, egg whites, etc.
- KNEADING RODS (9): They are designed to knead pastry and light dough.
• Place the rods in the corresponding holes pressing and turning round in order to have them correctly fixed.
Use always the rods together. Never use different rods together.
BLENDER STICK (6)
• It is screwed into the threaded hole (5). To place it, slide the lid of the stick blender upwards until the end and
keep it in that position to screw the stick blender.
• The blender stick (6) must not be placed if the rods are already placed.
BLENDER STICK FUNCTIONING.
• The blender stick only works keeping pressed the pusher "TURBO" having the speed selector (4) in "1"
position, when that pusher is released the blender stops.
RODS FUNCTIONING
• Select the speed with the selector (4).
• It is advisable to begin at the lowest speed (position 1) to then increase the speed to highest speed (position
5). However, and depending on the texture of the food, you may use the highest position from the start.
NOTE: Being working with the rods, the appliance will work with its maximum speed if you keep pressed the
turbo pusher (2), independently of the position of the speed selector (4).
• Once you have finished, set the speed selector (4) to "0" position and unplug it from the mains.
• To take out the rods (8-9) from the main body press the release button (3).
• ATTENTION: The rods can only be released when the speed selector (4) is in the "0" position.

MAINTENANCE AND CLEANING

• Before you proceed to cleaning, make sure the appliance is unplugged from the mains.
• The accessories may be cleaned with soap and water. Try to do it as soon as you finish using it, because dry
texture of some foods are difficult to take out.
• Clean the body of the blender with a cloth dampened in water.
• Do not use abrasive or chemical products, such as metallic scourers, which may deteriorate the surfaces of
the appliance.

ENVIRONMENT PROTECTION

• Dispose the appliance according to the local garbage regulations.
• Never throw it away to the rubbish. So you will help to the improvement of the environment.
9