Tabla de contenido
4
Installing the Ethernet Hub
Caution: Using an AC power adapter with incorrect voltage or
polarity may damage your Starlet Ethernet Hub. Make sure you
are using the correct power adapter before you connect the hub.
10Base-T Network Device to Hub Connection
To connect 10Base-T Ethernet network devices to your hub:
Normal
1
7.5VDC 500mA Normal Uplink
Interconnecting Hubs
To connect a second hub using a standard 10Base-T cable:
Uplink
1
7.5VDC 500mA Normal Uplink
Normal
1
7.5VDC 500mA Normal Uplink
• Make sure the Port 1 uplink
• Use standard 10Base-T cables
2
4
3
• Set the Port 1 uplink switch on
PRIMARY HUB
• Use a standard 10Base-T
2
3
4
• Make sure that the port you
SECONDARY HUB
2
3
4
• You can connect up to four
switch is set to Normal.
(category 3 or 5) to connect
the Ethernet port of each
network device to a port on the
hub.
the primary hub to Uplink.
cable (category 3 or 5) to
connect Port 1 on the primary
hub to any normal port on the
secondary hub.
connect to on the secondary
hub is not set to Uplink. (If you
connect to Port 1 on a Starlet
Ethernet Hub, set the uplink
switch to Normal.)
hubs using standard 10Base-T
cables.
Tabla de contenido
