Installation (SBC-165W)
1 Install the skin cover from the Intercom's front as if covering it.
2 To remove the installed skin cover, take off the screw at the bottom of the
Intercom and separate the Intercom's main body from the mount plate.
3 As shown in the figure, separate it while spreading the skin cover to both
ends.
TR20
Installation (SBS-165TM)
1 First, attach the Intercom's mount plate to the tilt mount on the wall, then
connect it to the Intercom's main body.
J
`
Before installing the tilt mount on the wall, it is necessary to consider
which direction the Intercom's front side will face. As shown in the
figure below, the up and down of the tilt mount changes as per the
installation direction. Check the arrow indicator of a wall on the side
of the tilt mount.
Wall
Indicator
of a wall
Wall
Installation (SHS-165F)
1 After attaching the Intercom to the flush mount, install it on the wall.
J
`
Before attaching the Intercom, confirm the up and down of the flush
mount.
2 When the installation of flush mount on the wall is completed, attach the
flush mount cover.
3 To take off the flush mount cover, separate it by pulling the area of a gap on
both sides while pressing the front part as shown in the picture.
PT01-005789B
