Putting Into Operation; Energy Saving Tips; Door Opening - IARP GLEE X-SLIM NV Instrucciones De Uso Para El Usuario

Modello - Modèle - Model
Modell - Modelo
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante

13. PUTTING INTO OPERATION

If the cabinet has been sharply tilted while being sited or for mounting of accessories, it must be left to stand for
at least three hours before being started to allow the lubricating oil to settle in the compressor.
Failure to do so can cause total destruction of the compressor refrigerating system.
Check that the voltage on the identification plate is the same as that of the network.
THE ELECTRICAL SUPPLY LINE TO WHICH THE REFRIGERATOR WILL
HAVE TO BE CONNECTED IS TO BE PROTECTED BY A VERY
SENSITIVE DIFFERENTIAL SWITCH (Rc=16A,Dc=30mA);
IT IS ALSO TO BE LINKED TO THE GENERAL EARTHING
PLANT.
Earthing is necessary and compulsory by law.
Absolutely never use reduction units, patch cords, adapters
or multiple socket outlets to connect the counter.
DIRECTLY connect the equipment to the mains.
The cable should be fully extended and located where it is unilikely to be struck, caught or stepped on,
away from water and the other liquids and heat sources and must not be damaged.
In case of breakage of the power cable of the cabinet, it must be replaced by the manufacturer or by
instruction it change of it.
L'installazione deve essere essere effettuata secondo disposizioni del costruttore, da personale qualificato e in conformità
alle vigenti normative elettriche dei paesi di destinazione del mobile.
Un'errata installazione può causare danni a persone, animali o cose, nei confronti del quale il costruttore non ha
nessuna responsabilità.
Il fabbricante declina ogni responsabilità per eventuali danni causati a persone o cose derivanti
dalla mancata osservazione di questa norma.

14. ENERGY SAVING TIPS

• Install the appliance in a dry, well-ventilated room away from heat sources (radiator, cooking surface and so on) and in a position
out of direct sunlight.
• Follow the installation instructions to ensure adequate ventilation. Insufficient ventilation to the back of the appliance causes an
increase in energy consumption and reduces cooling efficiency.
• The internal temperature of the appliance depends on the room temperature, how often the doors are opened and where the
appliance is placed. These factors have to be taken into account when setting the thermostat. Only open the doors when strictly
necessary.
• Let hot food and drink cool down before placing them in the appliance.
• The positioning of the shelves in the fridge has no effect on energy efficiency.
• The fridge compartment light system uses a LED light, which at the same time ensures more efficient lighting and reduced energy
consumption.
15. SPEGNIMENTO PROLUNGATO
When the unit is kept unused for a long time, please take note of the following procedures:
• Unplug the unit;
• Clean and dry the tank well;
• Leave the cover slightly open to avoid formation of bad odours;
• Cover the unit with a curtain, place it in a dry room and sheltered from the atmospheric agents.

16. DOOR OPENING

Warning! MAXIMUM ANGLE OF DOOR OPENING = 100°
For correct working of the torsion bar and to avoid any break of the door or of the hinge do not
exceed the maximum angle of door opening i.e. 100°.
All manuals and user guides at all-guides.com
GLEE X-SLIM NV
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
1 8 / 5 6
PAGE
UM000543
N° DOC
MAX
100°