Direction Switch; Removing The Lug Nuts; Reinstalling The Lug Nuts; Changing The 12 Volt Fuse - Kawasaki 691767 Manual De Instrucciones

DIRECTION SWITCH

The Impact Wrench can move in two
directions: Forward "FWD" for tightening,
Reverse "REV" for loosening.
REMOVING LUG NUTS
Use 12 Volt DC power ONLY. Any other voltage will dam-
age the tool.
1. Park vehicle in a safe outside location
away from moving traffic. Always set
the vehicle parking brake and block the
wheels so the vehicle will not move
while impact wrench is in use. In some
cars, the ignition switch needs to be set
to "ON" to power the cigarette Lighter
outlet.
2. Plug the 12 Volt plug-in into the vehicle's
12 Volt power supply. Verify that the
impact wrench LED light turns on.
This Impact Wrench does not work immediately like air-
operated or 120V wrenches. The tool must built up inertia before striking a
blow. This hesitation is normal and does not mean that the tool is broken.
3. Pick an impact socket that will fit the wheel lug nut. Press the socket onto the
anvil. NEVER use sockets that are not specifically designed for use with impact
wrenches.
4. Place a jack under the lift point for the wheel to be removed and raise the vehicle.
5. Support the vehicle by placing jack stands at locations recommended by the vehicle
manufacturer.
All manuals and user guides at all-guides.com
FWD
REV REV
FWD
FORWARD/REVERSE LEVER
VEHICLE 12V OUTLET
IMPACT WRENCH PLUG
11
Do not get under the vehicle without jack stands. Jacks
are not designed to maintain heavy loads for long periods of time.
6. Set the Directional Lever to "REV" and carefully loosen the lug nuts. Remove in
the order recommended by the manufacturer.
7. If the Impact Wrench cannot loosen the lug nut, use a breaker bar (not included)
to break the nut loose before trying again.
8. Remove wheel.
IMPORTANT INFORMATION FOR USE OF IMPACT WRENCH
To maintain the life of your Impact Wrench, it is recommended that you do not contin-
uously remove more than ten lug nuts. After ten lug nuts, let the Impact Wrench cool
down for approximately 10 minutes before attempting to remove additional lug nuts.
In general, after 10 minutes of operation, let the Impact Wrench cool down for approx-
imately 10 minutes before attempting to remove additional lug nuts.
REINSTALLING LUG NUTS
1. Lift wheel back into place.
2. Slide lug nuts onto the wheel bolts in the order recommended by the lug nut
manufacturer.
3. Hand tighten the lug nuts until securely fastened.
4. Do not tighten the lug nuts with the impact wrench. Excessive torque may cause
damage.
5. Use a torque wrench to check that the lug nuts are tightened enough per the man-
ufacturer's recommendations.
6. Remove jack stands. Carefully lower vehicle and remove the jack. Unplug the
impact wrench and store.

CHANGING THE 12 VOLT FUSE

Always replace fuse with a 10A-250V fuse of the same style.
1. Turn and remove the plastic cap and pull out fuse.
2. Insert new fuse inside the case and reinstall the fuse cap.
FUSE CASE
FUSE
FUSE CAP