Uline H-7490 Guia De Inicio Rapido página 2

2. Insert large Phillips head bolts through lower holes in
bottom shelf plate. Thread through support and into
threaded inserts in bottom shelf. Then, insert small
Phillips head bolts through upper holes in bottom
shelf plate and support. Secure with locknuts.
(See Figure 2)
NOTE: Make sure that two supports with notch
at top of support are facing each other on
opposite ends. Supports with rubber bumper
should also be on same side.
Figure 2
Lower
Holes
Notch
3. Attach middle shelf to supports with small Phillips
head bolts and locknuts. Make sure side of shelf
without lip is on same side as supports with notch.
(See Figure 3)
Figure 3
PAGE 2 OF 6
ASSEMBLY CONTINUED
Upper Hole
Bumper
Notch
Bumper
Support
Bumper
Notch
Bumper
Notch
Side
Without
Lip
4. Attach handle to supports without bumpers using
medium Phillips head bolts and locknuts. Brackets
on handle that bolts go through should be on inside
of support. (See Figure 4)
Figure 4
5. Attach top shelf to supports with small Phillips head
bolts and locknuts. Make sure side of top shelf
without lip is on same side as supports with notch.
Tighten all bolts fully. (See Figure 5).
Figure 5
1-800-295-5510
uline.com
0721 IH-7490