Küschal ULTRA-LIGHT Manual Del Usuario página 41

Rear side tie-down positions for snap hooks:
1. Attach the snap hooks to the rear frame right above the
adapter plate as shown in the two figures above (see location
of the attachment labels).
2. Attach rear straps to the rail system referring to best practice
recommended instructions from the safety belt manufacturer.
3. Tighten the straps.
IMPORTANT!
– Make sure that the snap hooks are covered with
slip resistant material to avoid laterally slipping
on the axle.
1583566-C
IMPORTANT!
– Check the plungers are fully engaged on both
sides and located in the same position of the
cut-out section of the rail.
– Make sure that the angle between the rails and
the straps lies between 40° and 45°.
Fit posture belt
WARNING!
The posture belt must be used in addition to but
never as a substitute for an approved passenger
restraint system (3-point belt).
1. Adjust posture belt to fit the wheelchair occupant, see section
4.1 Posture belt, page 22.
Fastening the 3-point passenger restraint system
Transport
41