Tecma Nano ECO Manual De Uso página 19

Installation, Con't.
8
H
3-1/2" 1(x)
Locate H position; cut hole.
10
D
DANGER:
Failure to use a Vented
Loop in raw water pump installation sites can lead
to water fl owing into the toilet from the outside
(siphoning) which can cause loss of property and
life! Refer to Installation Planning - "
Considerations"
to determine if a Vented Loop
is needed!
www.thetfordmarine.com
E
3
4
H
Vertical Installation
1. Choose installation method.
2. Run ; assemble parts as shown.
H
3. Tighten 1-1/2" to secure in place.
11
Test Toilet
BEFORE permanently attaching the toilet:
■ Flush the toilet to check toilet operation.
■ Verify no leaks; correct as needed.
■ Permanently insert
Raw Water
Operation
The ECO Rocker switch has two operation modes : "Add Water" (before use) and "Flush " (after use)
to be respectively activated by keeping pressed the upper or lower switch. The functions are clearly
indicated on the switch.
The "Add Water" function adds water in the bowl as long as the upper button is kept pressed. The
"Flush" function (after use) together activates the macerator pump and adds water inlet during the fl ush
as long as the lower button is kept pressed.
19
9
1-1/2"
Horizontal Installation
12
2
and into wall.
K4
K5
(2x)
1. Caulk along inside of trace line.
2. Place
3. Caulk around
3
H
1-1/2"
1
2
; insert into floor; secure.
1
base.
Caution!
Seal with silicone or latex
base sealant. Do not use Polysulfide base seal-
ants that can damage plastic.
Tecma Nano ECO Owner's & Installation Manual
4
1