T-Connector Wiring Kit
INSTALLATION INSTRUCTIONS
1. Read instructions thoroughly before beginning.
2. Open the rear trunk of the vehicle and remove the
plastic threshold. Pull back the trunk liner from both the
left (driver's) side and right
(passenger) side of the vehicle
to expose the vehicle's taillight
wiring harness connectors
(Fig. 1). They will be similar in
appearance to those found on the
T-Connector (Fig. 2).
3. Starting on the left (driver's)
side of the vehicle, separate the
grey connectors, taking care
not to damage the locking tabs.
Insert the T-Connector ends with
the Yellow wires between these separated ends,
ensuring the locking tabs fully engage.
4. Route the T-Connector ends with the Green wires out
from behind the trim panel under the plastic threshold to
the passenger side of the vehicle.
5. Repeat step 3 for the right (passenger) side of the
vehicle using the T-Connector ends with the Green wires.
6. Returning to the left (driver's) side, locate a clean
Fig. 1
Fig. 2
