Metra Electronics AX-ADXSVI-AU1 Instrucciones De Instalación

AX-ADXSVI-AU1
Audi CAN interface 2006-2013
Note: This harness must be used in conjunction with the AX-ADXSVI.
• Provides accessory (12-volt 10-amp)
• Retains R.A.P. (retained accessory power)
• Provides NAV outputs (parking brake, reverse, and speed sense)
• Prewired ASWC-1 harness (ASWC-1 sold separately)
• Retains balance and fade
• Micro "B" USB updatable
APPLICATIONS
AUDI
A3* 2006-2013
A4/RS 4/S4 w/ NAV 2005-2008
A4/RS 4/S4 2007-2008
INTERFACE COMPONENTS
• XSVI-AU1 harness
TOOLS REQUIRED
• Cutting tool • Tape • Crimping tool
• Connectors (i.e. butt-connectors, bell caps, etc.)
METRA. The World's best kits.™
Installation Instructions for AX-ADXSVI-AU1
FEATURES
A4/RS 4/S4*
TT 2008-2013
*Note: Only for models with either a
Symphony Plus or NAV radio.
1-800-221-0932
Caution: Metra recommends disconnecting the negative battery terminal before
beginning any installation. All accessories, switches, and especially air bag indicator
lights must be plugged in before reconnecting the battery or cycling the ignition.
*Note: Refer also to the instructions included with the aftermarket radio.
Connections to be made
From the XSVI-AU1 harness to the aftermarket radio
(a) From the 12-pin harness:
• Connect the Red wire to the accessory wire.
• Connect the Orange wire to the illumination wire, if the aftermarket radio has
no illumination wire, tape off the Orange wire.
• Connect the Blue/White wire to the amp turn on wire (this wire must be
connected to hear sound from the factory amplifier).
Note: There is a Blue wire on the 40-pin harness to connect as well.
The following wires are for aftermarket multimedia/navigation radios that provide
these wires (if not required, tape them off and disregard them):
• Connect the Light Green wire to the parking brake wire (if applicable).
2006
• Connect the Green/Purple wire to the reverse wire (if applicable).
• The Blue/Pink wire will not be used, tape it off and disregard it.
Note: This wire will be on the 40-pin harness instead.
(b) From the 40-pin harness:
• Connect the Black and Black/White wires to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Blue wire to the amp turn on wire (this wire must be connected
to hear sound from the factory amplifier).
The following wire is for an aftermarket multimedia/navigation radio that
provides this wire, if not required, tape it off and disregard it:
• Connect the Blue/Pink wire to the speed sense wire (V.S.S.), if applicable.
metraonline.com
(continued on next page)
© COPYRIGHT 2004-2014 METRA ELECTRONICS CORPORATION