Oregon Scientific WTGR800 Manual Del Usuario página 4

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 12
pole into a hard rocky type of ground as it may bend or
break the pole. It should be inserted into soft soil.
7. Place a wooden block on the top of the pole. With
a hammer, hit the wooden block to insert the pole at
a perpendicular angle to the ground until reaching
the base.
5
4
8. Assemble the mid-pole on top of the bottom pole.
9. Use the screw to fix.
10. Assemble the top pole to the mid-pole.
11. Use the screw to fix.
8
9
12. Assemble the wind sensor main body on top of the
pole. Use the screw (Type A) to fix.
13. Open the battery compartment.
14. Using a compass, rotate the wind direction part until
the NORTH indicator points to the "North".
15. Press RESET.
16. Close the battery compartment.
13
12
17. Insert the 2 rectangular base legs into the ground to
firmly fix the pole.
18. To keep the pole stable, use the 3 pins to firmly fix
the tension strings to the ground.
17
7
6
10
11
14
15
16
18
To set up the wind sensor main body on an existing pole:
1. Remove the screw that fixes the plastic connector
at the end of the top pole.
2. Slide down the plastic connector.
3. Detach plastic base from the bundled steel pole if
previously installed.
4. Assemble it at the end of the top pole using the
screw that is already attached on the base, with the
washers and bolts to fix.
1
2
5. Mount the plastic base on an existing pole.
6. Using the 2 U-bolts, secure the base on the pole
using the 4 washers and bolts.
7. Assemble the wind sensor main body horizontally to
the pole.
8. Use the screw to fix.
9. Open the battery compartment.
6
5
10. Using a compass, rotate the wind direction part until
the NORTH indicator points to the "North".
11. Press RESET.
12. Close the battery compartment.
13. Rotate the sleeve to the right to lock.
10
11
3
4
3
9
7
8
12
13
Tabla de contenido

Solución de problemas

loading

Tabla de contenido