Idiomas disponibles
Idiomas disponibles
1. Squeeze the metal clips on each side of the tray and slide the tray out.
2. Mount your hard drive or other internal 3.5" device into the drive tray by
threading the special screws through the bottom rubber grommets. Don't
over-tighten the screws, since that could decrease the grommets' ability to
absorb vibration and noise.
3. Slide the tray back into the case and lock it.
4. Connect a 4-pin white connector on the power supply to the male 4-pin
connector on the device.
5. If needed, repeat the same procedure for the other drives.
Note: You can mount the drives with the connectors facing toward or away
from you. If you mount them with the connectors facing away (into the case,)
you may wish to connect the data cables before sliding the drive into the locked
position. If you are installing Serial ATA drives we recommend positioning the
drives so that the connectors face outwards (i.e. towards you.)
Installing the Fan
We've included one rear-mounted 120mm cooling fan with vibration-reducing
rubber grommets. You'll also find a mount for an optional front-mounted
120mm fan.
The rear fan is installed so that the air blows out of the case. You'll find a large
4-pin white connector on the power supply. Connect it to the male 4-pin
connector on the fan.
The front fan (optional) should be installed so that the air blows into the case
from the front. For Quiet Computing™ we recommend that you NOT install the
front fan unless necessary for cooling, since it will create additional noise. To
mount the front fan:
1. Remove the front bezel by pressing the tabs on each side and pulling it
away from the chassis.
2. Install your optional 120mm fan, using the special long screws in the tool
bag.
3. Route the fan's power connector through the largest hole near the lower
right corner of the fan.
4. Inside the case, route the fan power connector behind the hard drive trays
and out near the motherboard.
5. Connect a large 4-pin white connector from the power supply to the fan
power connector.
6. Replace the front bezel.
Maintaining the Washable Air Filter
Your new case includes a washable air filter behind the front grill. To access it,
simply remove the front bezel. Initially, we recommend washing the air filter at
least once a month. By keeping the air filter clean, you'll help your system
remain stable and cool.
All manuals and user guides at all-guides.com
5
Antec Quality 3-Year parts and labor warranty (AQ3)
See details at: http://www.antec-inc.com/warranty.html
6
