Phoenix Contact MCR-SL-D-U/I Manual De Instrucciones página 9

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

CAUTION:
To prevent interfering signals caused by
the supply voltage, this input is isolated from the
supply voltage. Connect the signal line with the -
Signal to the analogue reference input.
ANLOGUE REFERENCE INPUT
If no isolation between measuring circuit and supply
voltage is necessary, connect pin 2 or 3 to this input
VOLTAGE INPUT
(Connect 7)
Analogue voltage input. Connect the signal line with
the analogue + signal with this input. In case of
reverse connection, the display shows „Err4".
CAUTION:
To prevent interfering signals caused by
the supply voltage, this input is isolated from the
supply voltage. Connect the signal line with the -
Signal to ana logue reference input.
3. Setting of the parameters
3.1 Selecting the displayed value
By pressing the right key, the display can be swit-
ched between the current, min., or max. value.
Pressing the right key once the current function
(„Act", „Min" or „Max") is displayed for 2 seconds. If
within this period the right key is pressed again, the
current function is changed. The display shows the
new current function for two seconds. Afterwards the
corresponding value is displayed. If „Min" or „Max" is
the current function, the value can be resetted by
pressing the left key. If neither storing of min. nor
max. value is activated in set up, both keys are out of
function.
3.2 Setting the operating parameters
a. Hold down both keys on front panel and switch
on the supply voltage.
b. The display shows
c. After releasing the keys the display alternates bet-
ween menu title and corresponding menu item at a
frequency of 0.5 Hz. After any key is pressed, only
the menu item is displayed.
d. Pressing the right key, the menu item will be swit-
(Connect 6)
ched to next value.
e. Hold down the left key and press the right key to
switch to the next menu title.
f. After programming the last menu item, the pro-
gramming routine will be left and the new values
will be stored by switching the menu item to „YES".
If you chose „NO", the programming routine will be
passed through once again.
4. Programming routine
Programmable parameters are shown in succession.
After one pass, the device is fully programmed.
In each case the first shown item is the factory preset.
4.1 Range of input signal
4.2 Max. value display
4.3 Max. value reset
0..20 mA
4..20 mA
0..10 V
2..10 V
Max. value can be dis play ed
Max. value wont be dis play -
ed, next menu title is skip-
ped
Max. value can be reset by
pressing left button. (Cur rent
value becomes new max.
value)
Max. value can't be reset.
9
Tabla de contenido
loading

Este manual también es adecuado para:

2864011-02

Tabla de contenido