Tabla de contenido
Idiomas disponibles
Idiomas disponibles
2
Safety instructions
Amperage
Before connecting this unit, check that the amperage
shown on the rating plate is the same as the power supply.
Operating this unit on an amperage other than
its rating plate may result in personal injury to the user and
damage the unit.
Preventive maintenance
After use, allow the tip to cool and remove the cleaning pad.
Neutralize with SURFOX-N and rinse the cleaning pad and
wand tip with water and dry. Clean dust and dirt deposits
from the exterior of the unit. Keep all
free of any obstructions. Clean the power cord to prevent
deterioration and check for possible damage to cord and
plug.
Note: Damaged cords must be replaced immediately by
personnel only. Refer to Spare Parts List for the
ordering number.
Transportation
Before transporting the machine, remove the electrolyte
solution cartridge and make sure all connecting lines are
disconnected. The machine must be carefully packed in a
suitable container and properly protected. WALTER will
not be held responsible for any damages resulting from
leaked cleaning solution or rough handling.
Storage
If the machine is to be stored for any length of time, the
solution cartridge and cleaning pad must be removed
(neutralized, rinsed and left off) and the insert neutralized,
rinsed and dried. Store in a dry safe place to avoid damage,
especially to the electronic components.
Waste disposal
Dispose of residual waste in compliance with Federal,
Provincial, State and local environmental regulations. Refer
to WALTER Material Safety Data Sheet of the SURFOX
electrolyte cleaning solutions.
Extension cord
When an extension cord is needed, use wire size 14 (AWG)
for up to 50 feet (15 meters) and size 12 (AWG) for 50 to
100 feet (15 to 30 meters).
6
All manuals and user guides at all-guides.com
on
vent openings
3
Equipment controls
Equipment controls
Control panel pictograms
POWER
3
3
2
2
1
1
Cleaning
Polishing
Marking
Etching
Power selector
Outlet for micro-wand
or marking wand
Micro-wand selector
Marking wand selector
INOX / STAINLESS
Ti
Application selector
Outlet for ground connector
Capítulos
Tabla de contenido
