Airrex HSCO-14 Manual De Operación Y Manual De Partes página 6

Operating Instruction & Parts Manual
INSTALLATION
WARNINGS REGARDING PROPER LOCATION FOR INSTALLATION
MOVING THE UNIT
Unlock the casters and push the unit to a flat, level surface and set the caster brakes to the locked position.
PLUGGING IN THE UNIT
Check the prongs and surface of the power cord plug for dust/dirt. If dust and/or dirt are present, wipe off
with a clean, dry cloth.
Check the power cord, plug and prongs for damage or excess play.
If any damage or excess play is found, contact a qualified repair technician or a qualified electrician to perform
replacement or repair of the power cord, plug or prongs
MEMO.
Do not use the unit in explosive environments or in areas where flammable gas
leakage may occur.
Do not use the unit in areas where it will be exposed to rain or water.
Do not use the unit in a corrosive atmoshpere.
Do not install the unit on uneven or sloping surface. The unit may roll or topple over
even if the casters are set to the locked position.
If the power cord or plug is damaged, repair should only be performed by qualified
electrical personnel.
Do not connect/disconnect the power cord or attempt to operate buttons with wet hands.
This could result in electrical shock.
rev0-2011