Koochi PUSHMATIC Manual Del Usuario página 15

OPERATION
1. LIST OF PARTS
Your pushchair is supplied in one carton and contains:
1. Pushchair (basket attached)
2. Hood
3. Footmuff
2. OPENING THE PUSHCHAIR
Release the catch (a).
Lift the handle (b) and unfold the chassis until it locks in the open position.
WARNING: Ensure that all locking devices are engaged before use.
3. FITTING THE REAR AXLE ASSEMBLY
Push the rear legs of the pushchair into the mounts on top of the rear axle assembly (a).
Ensure the spring loaded pins on the legs locate in the holes in the mounts (b) and the
assembly is secure.
To remove the rear axle assembly push in the spring loaded pins and pull the rear axle
assembly clear.
4. FITTING THE REAR WHEELS
To fit a rear wheel push the wheel onto the rear axle assembly until it stops (a). Press the
button in the centre of the wheel (b) and push the wheel again until it stops. Release the
button and check the wheel is locked in position by pulling the wheel back. Repeat this
procedure with the remaining wheel.
To remove a rear wheel, press the button in the centre of the wheel (c) then pull the wheel
clear of the axle.
5. FITTING THE FRONT WHEEL ASSEMBLY
Push the front leg of the pushchair into the mount on the front wheel assembly (a) until the
tabs on the front leg clear the base of the assembly (b) to lock it in place.
To remove the front wheel assembly press in the tabs (c) on the front leg then pull the
assembly clear.
6. USING THE SWIVEL WHEEL LOCK
Engaging the swivel lock: Move the front wheel assembly until the pin on the pushchair
leg and the lever on the wheel assembly align. Lift the lever to engage the swivel lock (a).
Releasing the swivel lock: Push the lever down to release the swivel lock.
7. USING THE BRAKE
To apply the brake, press the lever down firmly with your toe (a). Test the brake is
engaged correctly by trying to push the pushchair forwards for a short distance. To
release the brake, raise the lever (b).
NOTE: Always apply brake before loading or unloading a child from the pushchair.
8. ADJUSTING THE HEIGHT OF THE SEAT
The adjuster for raising and lowering the seat position is located behind the seat.
To lower the backrest push the button downwards to unlock the adjuster (a) and slide the
adjuster until the seat is in the desired position (b).
To raise the backrest slide the adjuster upwards (c) whilst holding webbing (d).
4. Headhugger
5. Rear axle assembly
6. Rear wheel (x2)
7. Front wheel assembly
8. Raincover
9. Kit bag