Solution Temperature; Start-Up Instructions - Walter BIO-CIRCLE MINI Manual Del Usuario

SOLUTION TEMPERATURE

The temperature control is factory set to maintain the solution at 41º C ± 1º
(106°F ±2°). At this temperature the bioremediation process is at its most efficient
level, cleaning is faster and operator comfort is at its best.
START UP INSTRUCTIONS
Please be sure to read and observe, the "SAFETY INSTRUCTIONS" at the
beginning of this manual. Detailed start-up instructions can also be found at
www.biocircle.com
1. Remove the BIO-CIRCLE™ Parts Cleaning System from its packaging and
check for any shipping damage. Should any be detected, DO NOT connect
the machine but report the damage to the transport carrier and to J. Walter.
The original packaging must be retained.
2. - Open the sink. Use the retainer bar at the back to maintain it in
the open position.
- Remove all packaging material around the unit and from inside the tank.
(ex.: from underneath or behind pump/heater coil)
- Remove filter housing (A+B+C+H) from inside the base and slide the
stainless bracket into the slot located in the back right hand corner of the
base. Do the same for the 3-way valve stainless bracket by inserting it
firmly in the sink. It is recommended to use a hammer and a screwdriver
in order to properly put in place the metal plate in the sink. Then add the
filter bag (M) under the sink. Make sure you replace the bag when it's full of
non-bioremediable waste. This filter bag will keep your liquid clean and will
increase the efficiency of the cleaning
- Connect the hose coming from the pump to the filter housing (H) IN fitting.
- Secure all connections with a hose clamp.
All manuals and user guides at all-guides.com
7
process.