LEGRAND Sanus SA-IWCM2 Instrucciones De Instalación

IN-WALL CABLE
MANAGEMENT KIT
SA-IWCM2
Installation Instructions
6901-602710
IMPORTANT
SAFETY INSTRUCTIONS
PLEASE READ ENTIRE MANUAL PRIOR TO USE
SAVE THESE INSTRUCTIONS
CAUTION:
Avoid potential personal injuries
and property damage!
• FOR LOW VOLTAGE CABLES ONLY.
• RISK OF FIRE - DO NOT install power supply cord within
the wall cavity.
• Do not use this product for any purpose not explicitly specified
by manufacturer.
• Manufacturer is not responsible for damage or injury
caused by incorrect assembly or use.
• If you do not understand these instructions or have doubts
about the safety of the installation, assembly or use of this
product, contact customer service.
We'll Make It Stress-Free
If you have any questions, just give us a call.
800-359-5520
SANUS.com
Legrand AV Inc. and its affiliated corporations and subsidiaries
(collectively, "Legrand"), intend to make this manual accurate and
complete. However, Legrand makes no claim that the information
contained herein covers all details, conditions, or variations. Nor
does it provide for every possible contingency in connection with
the installation or use of this product. The information contained in
this document is subject to change without notice or obligation of
any kind. Legrand makes no representation of warranty, expressed
or implied, regarding the information contained herein. Legrand
assumes no responsibility for accuracy, completeness or sufficiency
of the information contained in this document.
©2021 Legrand AV Inc. All rights reserved. SANUS is a brand of
Legrand. SANUS and the SANUS logo are registered trademarks.
All other brand names or marks are used for identification purposes
and are trademarks of their respective owners.
Legrand AV Inc.
6436 City West Parkway
Eden Prairie, MN 55344 USA
Tools Required
Pencil Level
1
LOCATE
Your Desired Location
(Verify your cord lengths)
Find you desired locations (between studs).
5
ASSEMBLE
Snap the lock tabs in place.
Stud Finder Tape
Measure
2
TRACE
Trace the template at your locations.
6
SCREW PREP
Hand tread the screws into the lock tabs.
Phillips Slotted
Screwdriver Screwdriver
3
CUT
Cut out the holes in the drywall.
7
SECURE
Insert into the wall and secure the
lock tabs by turning the scews.
Drywall
Saw
4
RUN CABLES
Run your low voltage cables.
8
FINISH
Install the cover plate.