Uline H-3760 Guia De Inicio Rapido

H-3760
H-UNIT SLATWALL
GONDOLA DISPLAY
TOOLS NEEDED
Rubber Mallet (Optional)
Phillips Screwdriver
Confirmat Screw x 8
Camlock x 21 Dowel Pin x 4
Kick Base Top x 1
KICK BASE ASSEMBLY
1. Set kick base top on a protective surface with the
underside facing up.
2. Using a screwdriver, install camlock pins into
predrilled holes in the kick base boards and the
underside of the base top. (See Figure 1)
3. Install camlocks into kick base boards by tapping
them into position with the rubber mallet. (See Figure 2)
NOTE: Ensure the opening of the camlock is
facing outward, and that the camlock is fully
seated into position.
4. Match kick base boards so that each corner has
camlock pins set into the camlocks of the adjacent
board. Boards of the same length should be parallel
to each other. The shortest, unfinished board should
be placed in the center. (See Figures 3 and 4)
PAGE 1 OF 6
1-800-295-5510
uline.com
Camlock Pin x 21 Pan Head Screw x 24
Screw Cap x 8
Short Kick Base
Board x 2
Unfinished Kick
Base Board x 1
PARTS
Caster x 6
Center Panel x 2
Long Kick Base Board x 2
ASSEMBLY
Figure 1
Camlock Pin
Figure 3
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
Wing Panel x 2
Figure 2
Camlock
Figure 4
0521 IH-3760