ELECTRICAL SAFETY
• Only connect the lamp to a properly fused and earthed socket outlet.
• Do not use the lamp if the connection cable or the plug is damaged.
• Only use connections and extension cables that are suitable for outdoor use.
• When using the device in wet or damp environments (e.g. rain), observe all safety measures for
working in such environments.
• Check that the lamp, power cord and connections for good conditions before operating the lamp.
• Never pull the power cord to move the product or disconnect the plug from the power outlet.
• Failure to observe the above instructions can result in electric shock.
SCOPE OF DELIVERY
LED Double Light, Lamp holder with handle, height-adjustable tripod, connection cable with safety
plug and operating instructions.
INSTALLING / USING
Attach the lamp housing (A) to the cross bracket (B).
To do this, loosen the screws (C).
Align the hole in the lamp housing bracket with the hole
in the cross bracket (B), reinsert the screws (C) and
tighten them.
Loosen the locking screw (D) on the tripod so that the
individual legs (E) of the tripod can be opened. To do
this, you have to slide the upper middle section (F) of
the tripod downwards.
For use it is absolutely necessary that the legs are fully
unfolded, this is the only way to achieve maximum
stability.
Now place the portable holder in the middle of the
tripod and hold it in this position. Now press the
holder firmly, but not too abruptly, onto the connecion
piece (G). Under certain circumstances it may be
necessary to release the retaining clips by pressing
the red buttons. Check whether the holder is securely
and firmly connected to the tripod by gently shaking it
- the red buttons should also be extended.
Grasp the telescopic rod of the tripod by the two rings shown on the right
and turn them to the left to loosen the telescopic rod and adjust the length.
After adjusting the height, turn the two rings to the right to lock the
telescopic rod again. Do not loosen or lock the telescopic rod too tightly, as
this may reduce stability or damage the rod. Also, do not pull the telescopic
rod out too far, a few cm less than the greatest possible length.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed