Installing A Printer (Windows Xp); Configuring Audio Ports - Toshiba Express Port Replicator II Manual Del Usuario

Installing a printer (Windows
1 Connect your printer to the parallel port on the port replicator.
2 Dock your computer in the port replicator.
3 Click Start, Settings, and then Control Panel.
4 Double-click Printers and Faxes.
5 Click Add a printer.
6 In the Add Printer Wizard window, click Next.
7 Select Local printer attached to this computer. Make sure
the "Automatically detect and install my Plug and Play printer"
checkbox is not selected.
8 Click Next.
9 Select USB001 (Virtual printer port for USB) from the "Use
the following port:" drop-down list.
10 Click Next.
11 Select the printer manufacturer and model.
12 If the printer came with an installation disk, click Have
Disk.... Otherwise, click Next.
13 Follow the onscreen instructions to complete the installation.

Configuring audio ports

You can playback or record audio either through the port
replicator's audio ports or the docked computer's audio ports.
However, you cannot use the audio ports on the docked computer
and on the port replicator at the same time.
By default, the audio ports on the port replicator are automatically
enabled each time you dock the computer. When you undock the
computer, the audio ports on the computer are automatically re-
enabled.
To change the default settings, you may need to manually adjust the
audio settings in Windows
NOTE
Setting up and using the port replicator
®
If your media player is running when you undock or dock, you must
close the application and wait approximately 10-15 seconds for the
new settings to take effect before restarting the application.
Configuring audio ports
XP)
®
, as described in this section.
25