Safety Instruction - G-Systems EB600 Manual De Instrucciones

Activate you warranty online http://g-systems.eu/warranty/
In case of ignition failure the ballast will try this operation 5x and after this stop
working. You have to start the ballast manually again. Once the bulb started it
needs 3-5minutes to get hot and shine on his full power. In case the ballast can
not start the bulb contact our support team using the live support on
http://www.g-systems.eu/
Stop the ballast
You can stop the ballast manually with the
1. OFF-Standby button, or disconnecting the power on the main cable. The
ballast stors your settings for about 72h and starts next time with the last
settings. After 72h disconected or OFF the ballast loses the settings and you
have to start it manually again.
Dim the bulb
You can dim a bulb only downwards, for example:
600W dim from 660W to 250W
400W dim from 440W to 250W
250W dim from 275W to 250W
All bulbs can run on overdrive which is 10% more output power to the bulb. To
run on overdrive push short to 2. Up button. The 3. LED overdriver is indicating
together with one of the LED mode 4-6. (We do not recommend it cause it
damages the bulb). GSE don't recommend to dim any kind of bulbs because the
light colour changes). For dimming push short to 2. Up / down button it steps at
once from 3. LED overdriver to 4. LED 600W mode to 5. LED 400W mode and
6. LED 250W mode. The ballast needs up to 2minute time to dim the bulb can
cool down his self. When you push the 2. Up / down button and hold it the
ballast dim variable. The LED are indicating the the value. Between 600W and
500W the 4. LED 600W mode shine and the 5. LED 400W mode is blinking,
between 500W and 400W the 5. LED 400W mode shine and the 4. LED 600W
mode is blinking. The same functions you have between 400W and 250W. The
ballast remembers thesettings at the next start, the ballast lose the settings after
72h disconnected or switch OFF you have to start manually again.

Safety instruction

The electronic ballast must be connected into a common household plug which
has a 10A, 13A or 16A safety breaker. If the ballast is not working, use our RMA
http://g-systems.eu/warranty/rma to return the ballast for repair.
EN
11