Idiomas disponibles
Idiomas disponibles
Thorough inspection
At least once per year a thorough inspection should be made and registered and these additional points checked:
All the jack stoppers, screws, and nuts should be checked and tightened it necessary.
All labels are legible.
Carefully check all of the exterior parts of the jack, no deformation, cracks or other damages allowed.
Pump up the jack completely until the safety release valve opens. There should be no oil leak.
Release the pressure of the pump and check the pillar to confirm the pillar is straight and without damages. The down movement shall be smooth
and without scraping.
When the jack is lowered the movement shall be stable and the jack must not be jammed. Slight vibrations are normal during the descend.
Add hydraulic oil
If the jack cannot be pumped up all the way, you may have to add hydraulic oil into the oil tank. The hydraulic fluid to be used must be in accor-
dance with ISO VG22 or equivalent. Mixing of different fluids is prohibited!
Storage and transportation
Storage
Store the completely descended jack in a dry place, protected from corrosion and mechanical impacts.
Transportation
The operating handle (02) is only for operating the jack, not to carry the jack. When transporting the jack, it must not be dropped or thrown around
because it may cause damage to the jack. Therefore, the jack should be fixed before transporting to avoid shocks/impacts with other objects.
End of use/Disposal
Toe jacks shall be sorted/scrapped as general steel scrap, after the hydraulic oil has been removed.
Your POWERTEX distributor will assist you with the disposal, if required.
Disclaimer
We reserve the right to modify product design, materials, specifications or instructions without prior notice and without obligation to others.
If the product is modified in any way, or if it is combined with a non-compatible product/component, we take no responsibility for the consequenc-
es in regard to the safety of the product.
Declaration of conformity
SCM Citra OY
Asessorinkatu 3-7
FI-20780 Kaarina
Finland
www.powertex-products.com
hereby declares that the POWERTEX product as described above is in compliance with EC Machinery Directive 2006/42/EC and EN 1494.
Troubleshooting guide
Items
Symptom
1
The pressure cannot be
pumped up
2
The jack cannot descend from
elevated position
3
The jack cannot be pumped up
to its max position
4
Oil has leaked around the
pump plunger
Possible cause
1. The release valve is not
closed properly.
2. Air inside the pump
The release valve is not
opened enough
Oil level is too low
Seals are damaged or worn
3
Aliments
1. Screw in the unload handle (16) tightly in clockwise direction.
2. Loosen screw (37) for 5T and 10T models, (39) for 25T model to
release the air from the pump, then screw it tightly again
Rotate the unload handle (16) in counter - clockwise direction
Remove screw (10) and add hydraulic oil
Replace seals with new seals (8) (9) for 5T and 10 T models, (7) (8)
for 25 T model. Spare seals delivered with the jack
