WUBEN T70 Manual Del Usuario página 5

Default output selections: When the light is on, single
2
click to cycle through Low-Med-High-Turbo. Press and
hold 2s to turn off the light.
Continuous output selections: When the light is on, triple
3
click to get into continuous output selections, start from
Low to Turbo and then Turbo to Low, release to select
thecurrent output, triple click again to switch into
default output selections mode.
Flashing mode: When the light is NOT on continuous
4
output brightness selection mode , double click to
switch between Strobe and SOS, then single click to exit
the flash mode.
Instant Turbo: Press and hold to activate turbo output,
5
then single click to turn off.
4. Lock and unlock
When the light is off, light blinks 3 times to indicate lockout
status.Then any operations on the switch will activate the
blue light in switch to indicate lockout status, except triple
click on the switch to unlock it.
5. Charging
Please make sure the light is off before charging. Connect
Type-C charging cable with the light and adapter of 5V /2A
to charge. It takes about 4h to fully charge the light ( based
on 5V /2A adapter ) .
Power under 15%
Power 15%~40%
Power 41%~90%
Power 91%~100%
Make sure the batteries with protection circuit board.
Make sure rubber cap covered well after charging finished to promise
the IP68 waterproof level.
Red light flashes
Red light constant on
Blue light flashes
Blue light constant on
- 05 - - 05 -
E
N