Burda RELAX GLASS IP65 Instrucciones De Montaje página 18

BRELG1500RD, BRELG1800RD, BRELG2200RD, BRELG3000RD
Operation instruction：
1, Plug in the device, and then press the switch to the position of I (refer to the picture 4). The device will sound 1 beep,
the heater will begin in Standby mode. At this time, the lowest power setting LED will be flashing to indicate the unit is
in Standby (picture 5).
∣：ON
О：OFF
picture 4
2、Point the remote control directly to the LED's, press 'LOW', 'MED', 'HIGH' to set your desired power setting. (Picture
6, 7, 8)
picture 6
LOW setting
3, To set the heater to standby mode point the remote control directly at the receiver and press 'STANDBY'. At this
time the lowest heat temperature setting LED will be flashing to indicate the unit is in STANDBY mode.
picture 9
picture 5
picture 7
MED setting
Main
power
switch
picture 8
HIGH setting
Remote control
18