Saber R50SB0412 Armado Del Asador Y Guía Del Producto página 26

Troubleshooting (continued)
Problem
Possible Cause
Faulty Integrated ignition circuit.
Burner(s) will not
light using ignitor.
Sparking somewhere other than between
burner and electrode.
See "GAS ISSUES:" on previous page.
Burner(s) will not
match light.
Improper method of match-lighting.
Flare-up. Grease build-up
Excessive fat in meat.
Excessive cooking temperature.
Persistent grease Grease trapped by food buildup around
fire. burner system.
Burner and/or burner tubes are blocked.
Flashback (fire in
burner tube(s).
Grease buildup or food particles in end(s)
One burner does
not light from other of carryover tube(s).
burner(s).
Troubleshooting - Integrated Electronic Ignition
Problem (Ignition) Possible Cause
SECTION l
No sparks appear at Battery not installed
any electrodes when
properly.
burner control knobs
are turned to ; no
noise can be heard Dead battery.
from spark.
Battery cap installed
properly.
Faulty spark module.
Switch wires
disconnected
SECTION ll
No sparks appear at
Output lead connections
any electrodes when
not connected.
burner control knobs
are turned to ;
Electrode tip not in proper
noise can be heard
position.
from spark.
26
All manuals and user guides at all-guides.com
Check Procedure
Check battery orientation.
Has battery been used
previously?
Check to ensure battery cap is
fully engaged.
If no sparks are generated with
new battery and good wire
connections, module is faulty.
Check to insure switch wires
are connected.
Are output connections on and
tight?
Are the electrode tips pointing
in the right direction? Is the
gap too big?
Prevention/Solution
See Troubleshooting Integrated Electronic Ignition section.
Inspect wire insulation and proper connections. Replace wires if
insulation is broken.
See "Match-Lighting" section of Use and Care.
Clean burners and inside of grill/firebox.
Trim fat from meat before grilling.
Adjust (lower) temperature accordingly.
Turn knobs to OFF. Turn natural gas OFF at dedicated shut off valve.
Leave lid in position and let fire burn out. After grill cools, remove and
clean all parts.
Turn knobs to OFF. Clean burner and/or burner tubes. See Burner
Cleaning section of Use and Care.
Clean carry-over tube(s) with wire brush.
Prevention/Solution
Install battery (make sure that "+" and "-" connections
are oriented correctly, with "+" end up and "-" end
down.
Replace battery with new alkaline battery.
Remove battery cap and reinstall, making sure it can
be fully engaged.
Replace spark module assembly.
Reconnect switch wires.
Remove and reconnect all output connections at
module and electrodes.
Tip of electrode should be pointing toward port hole
in burner. The distance should be 1/8" to 1/4".
Adjust if necessary.