Tabla de contenido
Idiomas disponibles
Idiomas disponibles
EMPTYING THE COLLECTION TANK
WARNING:
ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET BEFORE REMOVING
THE POWER HEAD FROM COLLECTION TANK.
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Disconnect the hose from the vacuum (Fig. 2).
3. Undo the latches and remove the power head from the collection tank (Fig. 3 & 4). Place power head on a soft, clean
surface upside down.
4. Clear all dirt or debris from the collection tank and hose into a proper waste container (Fig. 5).
5. Clean or replace the filters.
6. Check the hose, attachments, and power cord to verify that they have not been damaged.
7. Place the power head back on collection tank and secure latches.
IMPORTANT! Clean or change the filter regularly for best performance. ALWAYS USE THE REUSABLE CLOTH FILTER
FOR DRY VACUUMING. If the machine is used without the reusable cloth filter, the motor will burn out and the warranty
will be voided. Always keep spare filters on hand.
NOTICE! The filters included are made of high quality materials designed to stop small dust particles. The cloth filter
should be used for dry pick-up only. A dry reusable cloth filter is necessary to pick up dust. If the reusable cloth filter is
wet, it will clog quickly and be difficult to clean. Handle the filter carefully when removing it for cleaning and replacing.
Check the filters for tears or small holes. A small hole can let dust pass through and out of the filter. Do not use a filter with
holes or tears in it; replace it immediately.
STORAGE
Before storing your vacuum, the collection tank should be emptied and cleaned. The accessories should be cleaned and
stored so they can be readily available when needed. Store the wet/dry vacuum indoors.
REPAIRS
Repairs for this wet/dry vacuum should be performed only by qualified service personnel using only identical replacement
parts.
INSTALLING & CLEANING REUSABLE CLOTH FILTER
1
Installing Reusable Cloth Filter
1. Verify that the power cord is disconnected from the outlet (Fig.1).
2. Remove the power head and place it in an upside-down position.
3. Install reusable cloth filter over the filter cage making sure the cage is completely covered (Fig. 2 & 3).
4. Place the power head onto the collection tank.
Removing & Cleaning Reusable Cloth Filter
1. With the removed power head in an upside-down position, carefully remove the reusable cloth filter from the filter cage
(Fig. 4).
2. Clean the reusable cloth filter by gently tapping or brushing dirt off. Cleaning should not be done indoors in living
areas. For optimal performance a new filter is recommended.
3. Use a mild soap and water solution to wash reusable cloth filter and rinse with clean water (Fig. 5).
4. Allow the wet filter to air dry for 24 hours before installing onto the filter cage.
2
3
4
11
5
Tabla de contenido
