Connecting Fixtures In Series For External Control; Connecting The Led Fixture To The Mains - Lumatek ZEUS 465W PRO 2.9 Manual

6.7 Connecting fixtures in series for external control

For detailed instructions please refer to the Lumatek Control Panel manual.
Position and hang each fixture appropriately. Zeus series fixtures use 0-10V signal protocol for control.
Connect controller output signal cable to
fixture 1 SIGNAL IN connector.
Connect daisy-chain control signal cable (sold
separately) from fixture 1 SIGNAL OUT connec-
tor to fixture 2 SIGNAL IN connector.
Continue to connect fixtures in series for up to
100 fixtures per controller, see Fig.

6.8 Connecting the LED fixture to the mains

Warning! Make sure mains power is switched off.
Warning! Ensure the power supply cable is not coiled and does not touch any hot surfaces.
Warning! Connect the cables according to local rules, safety regulations and electrical code.
Warning! If not using an external lighting controller ensure external switching gear can cope
with theinrush current of the LED fixture. Always use a timer contactor suitable for switching
a capacitive load. Never use household timers to switch the LED fixture!
Warning! Do not connect or disconnect the LED fixture under load.
Ensure the LED driver power supply cable self-locking female connector is correctly aligned to the
corresponding male connector on driver and push together until click-locked. To disconnect;
turn twist-lock connector anti-clockwise to unlock and pull apart from driver.
Connect mains power plug to switching gear/power supply.
Switch on mains power.