Inverting The Output Signal; Application Examples (Pump With Pwm Control); Accessories - Resol PSW Basic Manual

ATTENTION! Malfunction!
Pumps with line break detection run with minimum speed if
the control signal is 0 V.
Î Do not operate pumps with line break detection
by a 0-10 V signal!
Connect the blue wire of the signal cable of the pump to GND. Depending on the
signal type, connect the brown wire to one of the following terminals:
0-10V Out =
0-10 V control signal for the HE pump
PWM Out = PWM control signal for the HE pump
The mains connection of the device is at the following terminals:
N = neutral conductor N
L = conductor L
The pump must be supplied by an external power source (230V~).
S H
Made in Germany
PSW Basic
Seriennummer
2.3

Inverting the output signal

By means of the three-pole jumper on the left-hand side above the output termi-
nals the output signal can be issued inverted or not inverted.
Jumper position left: not inverted (solar pump)
Jumper position right: inverted (heating pump)
Input
Heating (H)
100%
0%
T0,2A
220 ... 240 V~, 50-60 Hz
N L
Solar (S)
Output
S H
PWM
100%
0-10 V
2.4

Application examples (pump with PWM control)

S H Heiskampstraße 10
T0,2A
DE-45527 Hattingen
230 V~, 50 Hz
PSW Basic
N L
blue brown
X
black (not used)
Input signal:
230 V control signal from the controller (On / Off, burst / wave
packet, leading-edge phase cutting, trailing-edge phase cutting)
Signal cable
PWM
Signal input
Pump
3

Accessories

HE-Check – Testing device for PWM- and 0-10 V signals
With the HE-Check, the function of the pump and the sig-
nals of the controller can be checked quickly and easily.
Example: connection to a DeltaSol ® BS controller
IP 20
1 (1) A 100 – 240 V~
Temp. Sensor Pt1000
S1 S2 S3 S4 VBus
1 2 3 4 5 6 7 8 9 10 12 13 14
230 V~ / Mains connection
Power supply 230 V~ / Mains connection
yellow/green
blue
brown
Power supply pump
T4A
100 – 240 V~
50 – 60 Hz
N R1 N L
17 18 19 20
15