To Turn Off Gas To Appliance - SUREHEAT ReddyHeater IWH10NLTC Manual De Funcionamiento E Instalacion Del Propietario

Note: If pilot goes out, repeat steps 3
through 7. This heater has a safety inter-
lock system. Wait one (1) minute before
lighting pilot again.
8. Turn control knob counterclockwise
to desired heating level. The main burner
should light. Set control knob to any heat
level between 1 and 5.
Control Knob
THERMOSTAT CONTROL OPERATION
The thermostat used on this heater senses the room temperature. At times the room may
exceed the set temperature. If so, the burner will shut off. The burner will cycle back on when
room temperature drops below the set temperature. The control knob can be set to any comfort
level between 1 and 5.

TO TURN OFF GAS TO APPLIANCE

Shutting Off Heater
Turn control knob clockwise
OFF position.
MANUAL LIGHTING PROCEDURE
1. Remove lower front panel.
2. Follow steps 1 through 5 under Lighting
Instructions, page 17.
3. With control knob pressed in, strike match.
Hold match to pilot until pilot lights.
4. Keep control knob pressed in for 30 sec-
onds after lighting pilot. After 30 seconds,
release control knob. Follow step 8 under
Lighting Instructions, page 17.
5. Replace lower front panel.
18
All manuals and user guides at all-guides.com
OPERATION
just heating levels by using the
equipment shutoff valve.
NG, make sure NG pilot burner ig-
nites. If input gas type is LP, make
sure LP pilot burner ignites.
IWH10NLTC IWH16NLTC
Burners
Figure 20 - Burner Patterns
to the
Turn control knob clockwise
PILOT position.
Natural
Gas
Burner
www.sureheat.com
CAUTION: Do not try to ad-
WARNING: If input gas type is
IWH26NLTC
Shutting Off Burner Only (pilot
stays lit )
Ignitor
Electrode
Pilot Air
Inlet Hole
Pilot Air Inlet Hole
Figure 21 - Pilot Assembly
to the
Thermocouple
Propane/LP
Gas Burner
200041-01B